D-Link DXS-1210-12TC Reference Manual page 153

ip igmp snooping query-max-response-time SECONDS
no ip igmp snooping query-max-response-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This command configures the period
of which the group member can respond to an IGMP query message before the IGMP Snooping
deletes the membership.
Example
This example shows how to configure the maximum response time to 20 seconds on VLAN 1000.
Switch# configure terminal
Switch(config)#vlan 1000
Switch(config-vlan)# ip igmp snooping query-max-response-time 20
Switch(config-vlan)#
20-9
This command is used to configure the general query packet version sent by the IGMP snooping
querier. Use the no form of this command to revert to the default setting.
ip igmp snooping query-version {1 | 2 | 3}
no ip igmp snooping query-version
Parameters
NUMBER
Default
By default, this value is 3.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies to set the maximum response time, in seconds, advertised in
IGMP snooping queries. The range is 1 to 25.
ip igmp snooping query-version
Specifies the version of the IGMP general query sent by the IGMP
snooping querier.
150