D-Link DXS-1210-12TC Reference Manual page 348

decrease NN
info
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the system messages logged in the local message buffer.
Each message logged in the message buffer is associated with a sequence number. As a message is
logged, a sequence number starting from 1 is allocated. The sequence number will roll back to 1
when it reaches 100000.
When the user specifies to display a number of messages following the reference sequence number,
the oldest messages are displayed prior to the newer messages. When the user specifies to display a
number of messages prior to the reference sequence number, the newer messages are displayed
prior to the later messages.
If the command is issued without options, the system will display up to 200 entries starting from the
latest message.
Example
This example shows how to display the messages in the local message buffer.
switch# show logging
Total number of buffered messages: 2
#2 2013-08-02 16:37:36 INFO(6) Logout through Console (Username: Anonymous)
#1 2013-08-02 16:35:54 INFO(6) Port eth1/0/1 link up, 1000Mbps FULL duplex
switch#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
starts from the eldest message in the buffer.
Specifies the number of messages that occurred prior to the specified
reference sequence number. If the reference index is not specified, the
message display starts from the last message written in the buffer.
Specifies to display the system log global setting.
345