Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp subtype port-id mac-address
Switch(config-if)#
25-19
show lldp
This command is used to display the Switch's general LLDP configuration.
show lldp
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system's global configurations.
Example
This example shows how to display the LLDP system's global configuration status.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
190