D-Link DXS-1210-12TC Reference Manual page 326

Display Parameters
Interface
Action
Threshold
Current
State
40-5
This command is used to Display storm control trap state.
show snmp-server traps storm-control
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to Display storm control trap state.
Example
This command is used to Display storm control trap state.
Switch# show snmp-server traps storm-control
storm occur
storm clear
Switch#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
The interface ID.
The configured action, the possible actions are: Drop, Shutdown,
None.
The configured threshold.
The actual traffic rate which is currently flowing though the interface.
Its unit may be percentage, kbps, PPS based on the configured meter
mode. Because hardware can only counts by PPS, this value of this
filed may be a rough value for percentage and kbps.
The current state of storm control on a given interface for a given traffic
type. The possible states are:
Forwarding: No storm event has been detected.
Dropped: A storm event has occurred and the storm traffic exceeding
the threshold is dropped.
Error Disabled: The port is disabled due to a storm.
Link Down: The port is physically linked down.
Inactive: Indicates that storm control is not enabled for the given traffic
type.
show snmp-server traps storm-control
: Disabled
: Disabled
323