Show Ip Igmp Snooping Groups - D-Link DXS-1210-12TC Reference Manual

Parameters
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP snooping information for all VLANs where IGMP snooping is
enabled.
Example
This example shows how to display IGMP snooping global state.
Switch#show ip igmp snooping
IGMP snooping global state: Enabled
Switch#
This example shows how to display IGMP snooping information on VLAN 2.
Switch#show ip igmp snooping vlan 2
IGMP snooping state
Fast leave
Querier state
Query version
Query interval
Max response time
Robustness value
Last member query interval
Switch#
20-13
This command is used to display IGMP snooping group information learned on the Switch.
show ip igmp snooping groups [vlan VLAN-ID | IP-ADDRESS]
Parameters
vlan VLAN-ID
IP-ADDRESS
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies the VLAN to be displayed.

show ip igmp snooping groups

(Optional) Specifies the VLAN interface to be displayed. If no VLAN is
specified, IGMP snooping group information of all VLANs will be
displayed, at which IGMP Snooping is enabled.
(Optional) Specifies the group IP address to be displayed. If no IP
address is specified, all IGMP group information will be displayed.
: Disabled
: Enabled (host-based)
: Enabled (Non-active)
: v2
: 300 seconds
: 20 seconds
: 2
: 3 seconds
153