IP-ADDRESS [MASK]
INTERFACE-ID
HARDWARE-ADDRESS
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Used to display a specific ARP entry, all ARP entries, dynamic entries, or static entries, or entries
associated with an IP interface.
Example
This example shows how to display the ARP cache.
Switch#show arp
S - Static Entry
IP Address
-----------------
S 10.31.7.19
10.90.90.90
Total Entries: 2
Switch#
8-6 show arp timeout
This command is used to display the aging time of Address Resolution Protocol (ARP) cache.
show arp timeout [interface INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the configured ARP aging time.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies to display a specific entry or entries that belong to
a specific network.
(Optional) Specifies to display ARP entries that are associated with a
specific network.
(Optional) Specifies to display ARP entries whose hardware address
equal to this address.
Hardware Addr
-----------------
08-00-09-00-18-34
00-01-02-03-04-00
Specifies the interface ID.
IP Interface
Age (min)
-------------
---------------
vlan1
forever
vlan1
forever
84