D-Link DXS-1210-12TC Reference Manual page 186

Parameters
capabilities
inventory-management
Default
No LLDP-MED TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable or disable
transmitting LLDP-MED TLVs.
When disabling the transmission of the Capabilities TLV, LLDP-MED on the physical interface will be
disabled at the same time. In other words, all LLDP-MED TLVs will not be sent, even when other
LLDP-MED TLVs are enabled to transmit.
By default, the Switch only sends LLDP packets until it receives LLDP-MED packets from the end
device. The Switch continues to send LLDP-MED packets until it only receives LLDP packets.
Example
This example shows how to enable transmitting LLDP-MED TLVs and LLDP-MED Capabilities TLVs.
Switch# configure terminal
Switch(config)#interface ethernet 1/0/1
Switch(config-if)# lldp med-tlv-select capabilities
Switch(config-if)#
25-9
This command is used to enable a physical interface to receive LLDP messages. Use the no form of
this command to disable receiving LLDP messages.
lldp receive
no lldp receive
Parameters
None.
Default
LLDP is enabled on all supported interfaces.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable a physical
interface to receive LLDP messages. When LLDP is not running, the Switchdoes not receive LLDP
messages.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
(Optional) Specifies to transmit the LLDP-MED capabilities TLV.
(Optional) Specifies to transmit the LLDP-MED inventory management
TLV.
lldp receive
183