D-Link DXS-1210-12TC Reference Manual page 34

,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X session statistics. Using this command without
parameters will display information about all interfaces.Otherwise, the session statistics on the
specified interface will be displayed.
Example
This example shows how to display dot1X session statistics on Ethernet port 1/0/1.
Switch# show dot1x session-statistics interface eth 1/0/1
eth1/0/1 session statistic counters are following:
Octets RX
Octets TX
Frames RX
Frames TX
ID
AuthenticMethod
Time
TerminateCause
User Name
Switch#
3-16
This command is used to enable sending SNMP notifications for 802.1X authentication. Use the no
form of this command to disable sending SNMP notifications.
snmp-server enable traps dot1x
no snmp-server enable traps dot1x
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
DXS-1210 Series Smart Managed Switch CLI Reference Guide
interfaces will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
snmp-server enable traps dot1x
: 0
: 0
: 0
: 0
:
: Remote Authentication Server
: 0
:SupplicantLogoff
:
31