D-Link DXS-1210-12TC Reference Manual page 95

Use this command to display the IPv6 neighbor cache entry.
Example
This example shows how to display the IPv6 neighbor cache entry.
Switch# show ipv6 neighbors
IPv6 Address
-------------------------------------- ----------------- --------- ---- -----
FE80::200:11FF:FE22:3344
Total Entries: 1
Switch#
Display Parameters
Type
State
9-8 ipv6 nd ns-interval
This command is used to set advertised NS retransmission interval.
ipv6 nd ns-interval INTERVAL
no ipv6 nd ns-interval
Parameters
INTERVAL
Default
None.
Command Mode
VLAN Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to set advertised NS retransmission interval.
Example
This example shows how to set advertised NS retransmission interval.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
D – Dynamic learning entry.
S – Static neighbor entry.
INCMP: (Incomplete) Address resolution is being performed on the
entry, but the corresponding neighbor advertisement message has not
yet been received.
REACH: (Reachable) Corresponding neighbor advertisement
message was received and the reachable time (in milliseconds) has
not elapsed yet. It indicates that the neighbor was functioning properly.
STALE: More than the reachable time (in milliseconds) have elapsed
since the last confirmation was received.
PROBE - Sending the neighbor solicitation message to confirm the
reachability.
Retransmission interval in milliseconds.
Link-Layer Addr
00-00-11-22-33-44 vlan1
92
Interface Type State
D REACH