D-Link DXS-1210-12TC Reference Manual page 258

None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add or delete a time range profile for the system hibernation schedule. When
the system enters the hibernation mode, the Switch will go into a low power state and idle. It will shut
down all the ports and LEDs, all network function will be disabled, and only the console connection
will work via the RS232 port. If the Switch is an endpoint type Power Sourcing Equipment (PSE), the
Switch will not provide power to the port. This command can only be used when the stacking is
disabled.
Example
This example shows how to add a timerange profile for the hibernation schedule.
Switch# configure terminal
Switch(config)#power-saving hibernation time-range off-duty
Switch(config)#
32-6
This command is used to configure the timerange profile for the portshutdown schedule. Use the no
form of this command to delete the specified timerange profile.
power-saving shutdown time-range PROFILE-NAME
no power-saving shutdown time-range PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add or delete a time range profile for the port shutdown schedule. When the
schedule is up, the specific port will be disabled.
Example
This example shows how to add a timerange profile for the port shutdown schedule.
Switch# configure terminal
Switch(config)#interface eth1/0/1
Switch(config-if)# power-saving shutdown time-range off-duty
Switch(config-if)#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
power-saving shutdown time-range
Specifies the name of the timerange profile to be configured. The
maximum length is 32 characters.
255