D-Link DXS-1210-12TC Reference Manual page 109

Level: 12.
Usage Guideline
Use this command to clear the server screen log buffer. The DHCP server screen log buffer keeps
tracks the information of packet that does not pass the screening. The first packet that violates the
check will be sent to log module and recorded in the server screen log buffer. The subsequent
packets belonging to the same session will not be sent to log module unless its record in the log
buffer is cleared.
Example
This example shows how to clear the server screen log.
Switch# clear ip dhcp snooping server-screen log
Switch#
13-4
This command is used to define a server screen profile and enter the server screen configure mode.
dhcp-server-screen profile PROFILE-NAME
no dhcp-server-screen profile PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the DHCP server screen configuration mode to define a server screen
profile. The profile can be used to define the DHCP server screen entry
Example
This example shows how to enter the DHCP server screen configure mode to define the profile
"campus".
Switch# configure terminal
Switch(config)#service dhcp
switch(config)# dhcp-server-screen profile campus
switch(config-dhcp-server-screen)#
13-5
This command is used to enable or disable DHCP server screening.
ip dhcp snooping server-screen [SERVER-IP-ADDRESS [profile PROFILE-NAME]]
no ip dhcp snooping server-screen [SERVER-IP-ADDRESS]
DXS-1210 Series Smart Managed Switch CLI Reference Guide
dhcp-server-screen profile
Specifies the profile name with a maximum of 32 characters.
ip dhcp snooping server-screen
106