34-8
This command is used to display port level QoS configurations.
show mls qos interface INTERFACE-ID [, | -] {cos | scheduler | trust | rate-limit | queue-rate-
limit | dscp-cos-map }
Parameters
interface INTERFACE-ID
,
-
cos
scheduler
trust
rate-limit
queue-rate-limit
dscp-cos-map
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display port level QoS configurations.
Example
This example shows how to display the default CoS for eth 1/0/2 to eth 1/0/5.
Switch# show mls qos interface eth 1/0/2-5 cos
Interface
---------- ----
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
Switch#
This example shows how to display the port trust state for eth 1/0/2 to eth 1/0/5.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
show mls qos interface
Specifies the interface ID to display.
(Optional)Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional)Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to displays the port default CoS.
Specifies to displays the transmit queue scheduling settings.
Specifies to displays the port trust State.
Specifies to displays the bandwidth limitation configured for the port.
Specifies to displays the bandwidth allocation configured for the
queue.
Specifies to displays the mapping of DSCP to CoS.
CoS
Override
---------
3
Yes
4
No
4
No
3
No
270