D-Link DXS-1210-12TC Reference Manual page 28

dot1x pae authenticator
no dot1x pae authenticator
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for physical port interface configuration. Globally enable IEEE 802.1X
authentication on the Switch by using the dot1x system-auth-control command. When IEEE 802.1X
authentication is enabled, the system will authenticate the 802.1X user based on the method list
configured by the aaa authentication dot1x default command.
Example
This example shows how to configure Ethernet port 1/0/1 as an IEEE 802.1X PAE authenticator.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# dot1x pae authenticator
Switch(config-if)#
This example shows how to disable IEEE 802.1X authentication on Ethernet port 1/0/1.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# no dot1x pae authenticator
Switch(config-if)#
3-9 dot1x re-authenticate
This command is used to re-authenticate a specific port or a specific MAC address.
dot1x re-authenticate {interface INTERFACE-ID [, | -] | mac-address MAC-ADDRESS}
Parameters
interface INTERFACE-ID
,
-
mac-address MAC-ADDRESS
Default
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies the port to re-authenticate. Valid interfaces are physical
ports.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies the MAC address to re-authenticate.
25