L2 Features > L2 Multicast Control> Igmp Snooping > Igmp Snooping Groups Settings - D-Link DXS-1100 series User Manual

4 Configuration
After clicking Modify or Edit in IGMP Snooping Settings window, the following window will appear.
Figure 4.95 – L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping VLAN Settings
The fields that can be configured are described below:
Minimum Version: Select the minimum version of IGMP hosts that is allowed on the VLAN.
Querier State: Enable or disable the querier state.
Query Version: Select the general query packet version sent by the IGMP snooping querier. Options to
choose from are 1, 2, and 3.
Query Interval: Enter the interval at which the IGMP snooping querier sends IGMP general query messages
periodically.
Max Response Time: Enter the maximum response time, in seconds, advertised in IGMP snooping queries.
The range is 1 to 25.
Robustness Value: Enter the robustness variable used in IGMP snooping.
Last Member Query Interval: Enter the interval at which the IGMP snooping querier sends IGMP group-
specific or group-source-specific (channel) query messages.
Rate Limit: Enter the IGMP snooping rate limit used. Tick No Limit to ignore the rate limit.
Click Apply to accept the changes made.
Click the X button at the upper-right side to close the window.
L2 Features > L2 Multicast Control> IGMP Snooping > IGMP Snooping Groups Settings
This window is used to configure and view the IGMP snooping static group, and view IGMP snooping group.
D-Link 10 Gigabit Ethernet Switch User Manual
6 8
6 8