Parameters; Notes On Parameters In General - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
4.

Parameters

4.1

Notes on Parameters in General

Set parameters to determine the operating condition of the positioning unit.
The positioning unit can satisfy diversified needs through parameter setting in accordance with
the operation specifications and the control specifications.
Parameters are mainly classified into the following three types.
• Positioning parameters (PARA. 0 ~)
Determine the units, the speed, etc. for positioning control.
• I/O control parameters (PARA. 30 ~)
Determine the contents related to the I/Os of the positioning unit such as the method of
specifying the program No., the destination of the m code, etc.
• System parameters (PARA. 100 ~)
Determine the memory size of the program, the number of file registers, etc.
In the FX -20GM, the positioning parameters and the I/O control parameters for independent
2N
2-axis operation must be set for each of the X and Y axes. The parameters for simultaneous 2-
axis operation need only be set for the X axis. The settings for the Y axis are not required. In
the FX -10GM, the parameters must be set for one axis (the X axis) exclusively.
2N
Peripheral units
E-TP teaching panel
FX-PCK-KIT-98/GM personal
computer software
FX-30DU-GM data access unit
Parameter memory
Write
Power turned ON. MANU
to AUTO.
Special data registers
Overwrite
Positioning programs
Parameters 4
Read / Use
4-1