Outline Of Product - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
Reference manuals
1) E-20TP Operation Manual
This manual describes inputs, monitoring and tests of programs using the E-20TP .
2) FX-PCS-KIT-GM-EE Operation Manual
This manual describes inputs, monitoring and tests of programs using a personal
computer and the FX-PCS-KIT-GM-EE.
3) FX-PCS-VPS/WIN-E SOFTWARE MANUAL
This manual describes inputs, monitoring and tests of programs using a personal
computer and the FX-PCS-VPS/WIN-E.
Each of the above manuals is packed together with the corresponding unit.
Or you can acquire only manuals by asking a dealer from which you have purchased the
FX -10GM/20GM.
2N
1.2

Outline of Product

The positioning unit FX
"FX -10GM", "FX
2N
units to output pulse trains.
The positioning unit allows you to control positioning using a stepping motor or servo motor via
a drive unit.
1) Number of control axes (The number of axes indicates the number of controlled motors.)
One FX
2N
(The FX
2N
2) Positioning language
The positioning unit is equipped with a dedicated positioning language (cod instructions)
and sequence language (basic instructions and application instructions).
The FX
2N
without using the dedicated positioning language. (This is called the table method.)
3) Manual pulse generator
Manual feed is enabled when a general-purpose manual pulse generator (open collector
type) is connected.
4) Absolute position (ABS) detection
Returning to the zero point at every startup can be saved when a servo amplifier equipped
with absolute position (ABS) detection function is connected.
5) Connected PLC
Positioning data can be read/written when an FX
When an FX
Also the positioning unit can independently operate without any PLCs.
-10GM and the positioning unit FX
2N
-20GM" or "positioning unit" when indicating the both models) are special
2N
-10GM can control one axis. One FX
-20GM is equipped with linear/circular interpolation functions.)
-10GM can perform position control using programs saved in the PLC main unit
Series PLC is connected, an FX
2NC
-20GM (hereafter referred to as
2N
-20GM can control two axes.
2N
/ Series PLC is connected.
2N 2NC
-CNV-IF is required.
2NC
Introduction 1
1-2