System Configuration And I/O Assignment - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
1.4.5

System configuration and I/O assignment

FX -10GM
2N
The FX -10GM is equipped with a power supply, a CPU, operation system inputs, mechanical
2N
system inputs and an I/O drive unit. It can also operate inclependantly.
The FX -10GM is equipped with four input points (X0 to X3) and six output points (Y0 to Y5)
2N
for general purpose, and can be connected to external I/O equipment. If I/O points are not suf-
ficient, use the FX
At this time, the FX
(including FX
Series PLC. Up to four special units (including FX
counter) can be connected to an FX
I/O assignment shown inside ( ) indicates I/O points in the FX
I/O assignment
The FX -10GM units are treated as special units of the PLC. From the one nearest to the
2N
PLC, the special unit Nos. 0 to 7 are automatically assigned to the connected special units.
(This special unit No. is used the by FROM/TO instructions.)
Separate from I/O points in the PLC, and general-purpose I/O points in the FX
controlled as I/O points in the FX
For the details of assignment of I/O points in the PLC, refer to the FX
manuals.
-10GM together with an FX
2N
-10GM is treated as a special unit of the PLC. Up to eight special units
2N
-10GM, analog I/O and high-speed counter) can be connected to an FX
2N
2N
/ Series PLC.
2N 2NC
2N
Series PLC.
2NC
-10GM. (One PLC occupies eight I/O points.)
-10GM, analog I/O and high-speed
-10GM.
2N
/ Series Hardware
2N 2NC
Introduction 1
2N
-10GM are
2N
1-8