FX Series Positioning Controllers
d' e' Operation speed
Set these operands to operate the machine at a speed less than the maximum speed (set
to PARA. 4). If these operands are not set, the machine operates at the maximum speed.
When programming, use "f" only for both fx and fy.
Table 5.9:
Specification method
Direct specification
Indirect specification (16-bit) fD0 to fD6999 *2
Indirect specification (32-bit) fDD0 to fDD6998 *2
*2: D2000 to D3999 are not available in the FX
Program example
PARA.0 :System of units. Setting = "1"
(motor system of units)
PARA.3 :Minimum command unit.
Setting = "2" (10
cod91 (INC); Incremental drive method
cod00 (DRV)
x1000
f2000;
Specification method
Set range
f0 to f200,000
1
)
uuu
-10GM.
2N
Program format 5
5-20