Mitsubishi FX2N-10GM Hardware / Programming Manual page 109

FX Series Positioning Controllers
PARA. 103: Battery status output No.
Set the output No. in the FX
Table 4.58: Battery status output No.
FX
PARA. 104: Subtask start
Set the subtask start command timing.
Table 4.59: Subtask start
Setting = "0" :Starts a subtask when the mode is changed from MANU to AUTO (initial value)
Setting = "1" :Starts a subtask when the input specified by PARA.105 is turned ON.
Setting = "2" :Starts a subtask when the mode is changed from MANU to AUTO or when the input
specified by PARA.105 is turned ON.
PARA. 105: Subtask start input No.
Set the subtask start input No. when PARA. 104 is set to "1" or "2".
Table 4.60: Subtask start input No.
X0 to X3, X375 to X377
PARA. 106: Subtask stop
Set the subtask stop command timing.
Table 4.61: Subtask stop
Setting = "0" :Stops a subtask when the mode is changed from AUTO to MANU (initial value).
Setting = "1" :Stops a subtask when the input specified by PARA.107 is turned ON or when the mode
is changed from AUTO to MANU.
PARA. 107: Subtask stop input No.
Set the subtask stop input No. when PARA. 106 is set to "1".
Table 4.62: Subtask stop input No.
X0 to X3, X375 to X377
-20GM when PARA. 102 is set to "2".
2N
-10GM
2N

Setting = Output relay (Y) No. in a range of 0 to 67. Initial value=0
FX -10GM
2N
FX -10GM
2N
FX -10GM
2N
FX -10GM
2N
FX -20GM
2N
FX -20GM
2N
FX -20GM
2N
X0 to X67, X372 to X377
FX -20GM
2N
FX -20GM
2N
X0 to X67, X372 to X377
Parameters 4
4-33