Terminal Block; Outside Dimensions - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
1.7

Terminal Block

A terminal block converts the I/O area of a positioning unit or a connector type extension block
from a connector into a terminal block.
The following terminal blocks are available.
FX-16E-TB
FX-32E-TB
FX-16E-A1-TB
FX-16EY...-TB (... = R, S or T) : For only output, 16 points, can be connected to extension
FX-16EYT-H-TB
You can use a terminal block for only AC input or for only output to convert a connector type
extension block connected to the FX
not connect such a terminal block to the I/O area of the positioning unit.
For the details of terminal blocks, refer to an instruction manual offered together with each ter-
minal block.
1.7.1

Outside dimensions

: For both input and output, 16 points, can be connected to
positioning unit and extension block
: For both input and output, 32 points, can be connected to
positioning unit and extension block
: For only AC input, 16 points, can be connected to extension
block (cannot be connected to positioning unit)
block (cannot be connected to positioning unit)
: For only output, 16 points, can be connected to extension
block (cannot be connected to positioning unit)
-20GM into a terminal block. Have in mind that you can-
2N
¨
¨
Introduction 1
1-24