Output Specification - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
2.5

Output Specification

Table 2.6: Output Specification
Item
Signal name
Output circuit
configuration
Circuit isolation
Operation indication
External power supply
Load current
Open circuit leak current
Output ON voltage
Response time
Turning ON rate of I/O
simultaneously
Pulse output waveforms
The following types of pulse waveforms are output to a drive unit.
You do not have to set the pulse output waveform using parameters. The pulse output wave-
form automatically changes in accordance with the practical frequency.
1) In the case of interpolation drive instructions (FX
When a simultaneous 2-axis drive instruction (cod 01/02/03/31) is given, the following wave-
form is acquired at the operation frequency of 1 Hz to 100 kHz.
2) In the case of other drive instructions
• When the operation frequency in the FX
to 2.5 µs. Accordingly, the ON period becomes equivalent to the OFF period at 200 kHz.
• When the operation frequency in the FX
50%/50%.
• When the operation frequency in the FX
50%/50%.
General-purpose output
Y00 to Y07
By photocoupler
LED is lit while output is ON
5 to 24V DC ± 10%
50mA or less
0.1mA/24V DC or less
0.5V max (CLR is 1.5V max.)
0.2ms max. for both OFF → → → → ON and
ON → → → → OFF.
50% or less (FX -20GM)
2N
2N
2N
2N
Output to drive unit
FP , RP, CLR
20mA or less
Pulse output FP RP is 200kHz max.
Pulse output width of the CLR signal:
Approx. 20msec.
-20GM)
2N
OFF
ON
5µs(constant)
-20GM is 200 to 101 kHz, the ON period is fixed
-20GM is 100 kHz to 1 Hz, the ON/OFF ratio is
-10GM is 200 kHz to 1 Hz, the ON/OFF ratio is
Specifications 2
2-6