FX Series Positioning Controllers
1.4.7
I/O connector
FX
-10GM
2N
All terminals with identical names are shorted internally. (Ex. COM1-COM1, VIN-VIN, etc.)
Do not wire " y " terminals.
Refer to the FX
information.
FX
-20GM
2N
All terminals with identical names are shorted internally. (Ex. COM1-COM1, VIN-VIN, etc.)
Do not wire " y " terminals.
The pin assignment shown above indicates connectors of the positioning unit.
When you create an I/O cable by yourself, " " on the connector of the cable is regarded as pin
No. 20. Pay rigid attention to the positions of " " and notches.
• Perform Class 3 grounding with an electric wire of 2 mm
in the positioning unit. However, never perform common grounding with a strong power
system.
-10GM, FX
-20GM HARDWARE PROGRAMMING MANUAL for wiring
2N
2N
Introduction 1
2
or more to the ground terminal
1-12