Table of Contents
Advertisement
FX Series Positioning Controllers
1.4.2
Installation method
The positioning unit can be directly attached to a DIN rail DIN46277 (width: 35 mm).
When removing the positioning unit, slightly pull out the DIN rail hook.
When the DIN rail hook is pulled out by one more step, it can be locked in the open status.
When using an extension block for the
FX
Series together with the FX
2NC
push out the mounting hook in the arrow
direction shown in the figure on the right,
when attaching it to the DIN rail.
(An extension block cannot be connected to
the FX
-10GM.)
2N
1.4.3
MANU/AUTO selector switch
Set this switch to "MANU" for manual operation, or to "AUTO" for automatic operation.
Select the MANU mode when writing programs or setting parameters.
In the MANU mode, positioning programs and subtask programs stop.
When this switch is changed over from "AUTO" to "MANU" during automatic operation, the
positioning unit performs the current positioning operation, then waits for the END instruction.
Extension
-20GM,
2N
block
Introduction 1
1-5
- Quick Links:
- Positioning Program
Hide quick links:
Advertisement
Table of Contents
