Mitsubishi FX2N-10GM Hardware / Programming Manual page 144

FX Series Positioning Controllers
Interrupt Drive Instructions
The inputs shown in the table below are assigned as the stop commands and deceleration
commands for interrupt drive control.
Table 5.15: Interrupt Drive Instructions
Input
X00
X01
X02
X03
X04
X05
X06
Because these inputs are treated as general-purpose inputs and can also be used with a man-
ual pulse generator they may not be available. (Refer to PARA. 39 (manual pulse generator)
described in Section 4.4.3.)
FX -10GM
2N
cod 72 : x axis speed-change input
cod 72 : x axis stop input
cod 71 : x axis
cod 31
FX -20GM
2N
cod 72 : x axis speed-change input
cod 72 : x axis stop input
cod 72 : y axis speed-change input
cod 72 : y axis stop input
cod 71 : x axis
cod 71 : y axis
cod 31 : Simultaneous 2-axis
Program format 5
5-34