Mitsubishi FX2N-10GM Hardware / Programming Manual page 56

FX Series Positioning Controllers
• Make sure to shut down the power supplies of all phases on the outside before starting
installation or wiring.
If the power supplies are not shut down, you may get electrical shock or the unit may be
damaged.
• When the programmable controller is used, refer to the hardware manual of the program-
mable controller and perform correct wiring.
• When the 24V DC of the FX
refer to "When the FX
• For the number of extension blocks connected after the FX-10GM, refer to Section 1.4.5.
• Never touch any terminals while the power is supplied.
If you touch a terminal while the power is supplied, you may get electrical shock or the
unit may malfunction.
• Turn off the power at first, then start cleaning or tighten terminals.
If you perform cleaning or tightening while the power is supplied, you may get electrical
shock.
-10GM is not supplied from the programmable controller,
2N
-10GM operates independently" on the previous page.
2N
Wiring 3
3-4