Wiring; Wiring Of Power Supply - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
3.

Wiring

This section describes the wiring related to the positioning unit.
After finishing wiring, it is recommended to check the wiring by JOG operation before writing a
program. (At this time, set the positioning unit to the MANU mode. The JOG speed is deter-
mined by the setting of PARA. 5.) (Refer to Paragraph 4.3.1.)
3.1

Wiring of Power Supply

When independently using the positioning unit
FX-30DU-GM
DC24V
-15%
+10%
*1 The name is different such as
• Perform common grounding to
• When power is supplied from another power supply to the FX-30DU-GM, perform common
grounding to
the power supply.
Extension block
FX -10GM
for input (only in
2N
FX -20GM
FX -20GM)
2N
2N
Class 3
DC24V
grounding
-15%
+10%
,
FG
in the FX-30DU-GM and
Drive unit
*1
and in each drive unit.
PE
in the positioning unit and
in the positioning unit, and connect "24-" in
Wiring 3
in the drive unit.
3-1