Mitsubishi FX2N-10GM Hardware / Programming Manual page 101

FX Series Positioning Controllers
PARA. 34: Ready (RDY) output valid
Set whether or not to output the ready (preparation completion) signal of the positioning unit.
Table 4.37: Ready (RDY) output valid
Setting = "0" : Invalid
Setting = "1" : Valid (PARA.35 must be set.)
PARA. 35: RDY output No.
Set the output point No. from which the RDY signal is output when PARA. 34 is set to "1". (One
point is occupied.)
Table 4.38: RDY output No.
PARA. 36: m code external output valid
Set whether or not the m code is output to the outside using general-purpose output of the
positioning unit.
(When the positioning unit is connected to the FX
through communication with the buffer memory.)
Table 4.39: m code external output valid
Setting = "0" : Invalid
Setting = "1" : Valid (PARA.37 and PARA.38 must be set.)
Even when PARA. 36 is set to "0 (invalid)", the special relays and the special data registers
(such as the m code, the m code ON signal, the m code OFF signal, etc.) related to the m code
are still valid. When PARA. 36 is set to "1", PARA. 37 and PARA. 38 must be set.
PARA.37: m code external output No.
Specify the head No. of the output destination of the m code from the positioning unit.
This parameter occupies 6 points in the FX
Table 4.40: m code external output No .
Y0
m code ON output: Y0 (1 point)
m code output (1-digit BCD): Y1 to Y5
Occupies 6 points in total.
*1 Y1 to Y4 output one digit. Y5 turns on when the second digit is "1", "3", "5", "7" or "9".
(In the FX
2N
one bit of the second digit.)
PARA. 38: m code OFF command input No.
Specify the input No. of the positioning unit to which the m code OFF command is entered.
Table 4.41: m code OFF command input No .
X0 to X3, X375 to X377
FX -10GM
2N
FX -10GM
2N
Y0 to Y5
FX -10GM
2N
FX -10GM
2N
*1
-10GM, the number of output points is fixed to "6". Accordingly, it outputs only
FX -10GM
2N
/ Series PLC, the m code can be sent
2N 2NC
-10GM, and 9 points in the FX
2N
Y0 to Y57
m code ON output: Specified head No. (1 point)
m code output (2-digit BCD): Consecutive 8 points
(5 points)
Occupies 9 points in total.
FX -20GM
2N
FX -20GM
2N
Y0 to Y67
FX -20GM
2N
-20GM.
2N
FX -20GM
2N
FX -20GM
2N
X0 to X67, X372 to X377
Parameters 4
4-25