Positioning Operation In Which Movement Quantity Is Variable (Fx 2N -10Gm, Fx 2N -20Gm) - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
9.3.4 Positioning operation in which movement quantity is variable (FX
1) Outline of positioning
A digital switch is connected to the positioning unit, and the machine moves by the move-
ment quantity set by the digital switch.
2) Operating procedure
c The feed quantity (incremental value) is set from the digital switch. (For a connection
example, refer to the attached connection diagram.)
d By the start command from the outside, the machine moves by the quantity set in c.
e When movement is completed, the output Y5 turns on.
3) Operation chart
4) Program
Line No.
Ox0, N0
N1
N2
N3
N4
N5
O100,N0
N1
N2
N3
In order to read the digital switch, the digit changeover time (initial value = 20 msec) should
be set by PARA. 33.
When a digital switch is connected to the FX
time is fixed to "7 ms". As a result, the operation time is reduced.
5) Parameter
Set the positioning parameter No. 16 (mechanical zero point address) to "0". For other
parameters, refer to Paragraph 9.2.4.
Speed
The output Y5 turns on.
The X axis start input turns on.
("One short 10 msec or more" turns on.)
Instruction
RST Y5;
cod91(INC);
cod92(SET) x0 ;
cod00(DRV) XD0;
SET Y5;
m02(END);
P0;
FNC72(EXT) X0 Y0 D0 K5; (Head No. for digital switch connection input: X0
FNC04(JMP) P0;
ml02(SEND);
Movement distance
Description
Turns off the output Y5.
Specifies the incremental address.
Sets the current value to "0".
Moves the machine by the quantity set to D0.
Turns on the output Y5.
(X0 to X3 will be used.))
(Head No. for digital switch connection output: Y0)
(Data storage destination: D0)
(Number of digits: 5 (Y0 to Y4 will be used.))
-10GM / 20GM main body, this changeover
2N
Program Examples 9
-10GM, FX -20GM)
2N 2N
9-10