Mitsubishi FX2N-10GM Hardware / Programming Manual page 35

FX Series Positioning Controllers
I/O cable FX-16E-500CAB-S
• The figure above indicates the pin assignment when the connector is seen from the side on
which the positioning unit/extension block is connected (engaged).
Creation of I/O cable
We offer set parts of connectors for flat cables and unbound wires so that you can create I/O
cables by yourself.
Electric wires and crimp tools are to be prepared by you.
Table 1.3: Creation of I/O cable
Model name and configuration of I/O connector
Model name in
Mitsubishi
FX -I/O-CON for flat
2C
cable (10 connectors)
FX -I/O-CON-S for
2C
unbound wire (5 sets)
FX -I/O-CON-SA for
2C
unbound wire (5 sets)
*1 When using unbound wires, you may not be able to smoothly insert them into a housing due
to dispersion in the sheath thickness. We recommend wires UL-1061.
Included parts
(manufactured by
Daiichi Denshi)
Crimp connector FRC2-
A020-30S
Housing HU-200S2-001
Crimp contact HU-411S
Housing HU-200S2-001
Crimp contact HU-
411SA
Unbound wires
(Connected to a
relay terminal block,
general-purpose I/O
unit, etc.)
Applicable electric wire and tool
Electric wire size
2
AWG28 (0,1 mm ), 1.27
pitch, 20-core
2
AWG22 (0.3 mm )
2
AWG20 (0.5 mm )
Introduction 1
*1
Crimp tool
(manufactured by
Daiichi Denshi)
Main body 357J-4674D
Attachment 357J-4664N
357J-5538
357J-13963
1-23