Interrupt Stop (Fx 2N -10Gm, Fx 2N -20Gm) - Mitsubishi FX2N-10GM Hardware / Programming Manual

FX Series Positioning Controllers
9.3.5 Interrupt stop (FX
1) Outline of positioning
When the interrupt input X3 (X6 in the FX
stops, then proceeds to the next step while ignoring the remaining distance.
2) Operating procedure
c The machine returns to the zero point by the start command only at the first time. After
that, the machine moves to the target position.
d When the interrupt input X3 turns on during operation, the machine decelerates and
stops, then proceeds to the next step while ignoring the remaining distance.
e After the output Y0 turns on and off, the machine returns to the address "0".
3)Operation chart
4)Program (FX
Line No.
Ox0, N0 *
N1
N2
N3
N4
N5
N6
N7
N8
N9
N10
* In the FX
5) Parameter
Set the positioning parameter No. 16 (mechanical zero point address) to "0". For other
parameters, refer to Paragraph 9.2.4.
Caution
If this program is executed in the FX
gram) cannot be controlled because instructions for simultaneous 2-axis operation are actually
used.
-10GM, FX -20GM)
2N 2N
Speed
Mechanical
zero point
-10GM)
2N
Instruction
LD M9057;
FNC00(CJ) P126;
cod28(DRVZ);
P126;
cod31(INT) x1000 f1200;Sets the target address to "1000".
SET Y0;
cod04(TMR) K150;
RST Y0;
cod04(TMR) K150;
cod00(DRV) x0 f1200;
m02(END);
-20GM, change this portion to "O0, N0".
2N
-20GM) turns on, the machine decelerates and
2N
X3 ON
Target address
(1,000)
Description
Jumps to P126 if the zero point return completion
flag M9057 is ON.
Returns the machine to the zero point
(mechanical zero point address = 0).
Turns on Y0.
Sets the operation wait time to "1.5 sec".
Turns off Y0.
Sets the OFF wait time to "1.5 sec".
Returns the machine to the zero point.
-20GM, the Y axis (which is not controlled in this pro-
2N
Program Examples 9
Distance
9-11