Mitsubishi FX2N-10GM Hardware / Programming Manual page 261

FX Series Positioning Controllers
10.2.3 Error code list
Table 10.3: Error code list
Error
category
No error
System
parameter
Parameter
setting
errors
Program
error
Error
Details
code
0000 No error
If one of the parameters
1100 100 to 111has been set
to incorrectly, the corre-
1111 sponding error code 1100
to 1111 is displayed.
If one of the positioning
parameters 0 to 24 or the
2000
I/O control parameters 30
to
to 56 is set incorrectly, the
2056
corresponding error code
2000 to 2056 is displayed.
Program No. does not
exist.
When the start command
3000
is given in the AUTO
mode, the specified pro-
gram No. does not exist.
"m02(END)" is not pro-
vided in the program.
3001 The m02 (END) command
is not provided at the end
of the specified program.
Set value register overflow
3003 When the set value
exceeds 32 bits.
The set value is defective.
3004 When you input the value
outside a set range.
The imperative type is
defective.
When setting (moved dis-
3005 tance and speed) which
cannot be omitted is omit-
ted or the set value of
another axis is input.
The label to the CALL and
3006 the JUMP instruction is
absent.
The CALL instruction is
defective.
Nest levels exceeds 15
3007
piles. Or, the CALL does
not correspond to the
label of the RET.
Simultaneous
Reset
2-axis mode

Make sure that the
parameter setting
evaluated as error is
within the set range.
Change the pro-
gram No. or create
the program.
Add "m02 (END)" at
the end of the speci-
fied program.
Change the set
value to the value of
32 bits or less.
Change the set value
to the value within
the range of setting.
Confirm the pro-
gram form after of
each instruction.
Program the label at
the jump destina-
tion the call ahead.
Adjust nest levels to
15 piles or less.
Moreover, please
confirm the lavel
number.
Troubleshooting 10
Independent
2-axis mode
 
Global error Global error
Local error Local error
Global error Local error
Local error
Local error
Global error
10-5