NEC Univerge sv8500 Manual page 829

Follow the procedure below when changing the assigned data.
Note 3:
<e.g. When DHCP server is not used>
Input (Y:OK / N:Change / Q:Quit) : n
Change list.
DHCP
OWN IPADDRESS
OWN SUBNETMASK
DEFAULT ROUTE
DRS1 ADDRESS
Input (Q:Quit) : 1
Follow the display below when you want to change the data entered in the former steps.
Note 4:
<e.g. When DHCP server is not used>
OWN IP ADDRESS [1.1.1.10] :1.1.1.12
SUBNET MASK [255.255.255.0] :255.255.0.0
DEFAULT GATEWAY [1.1.1.254] : b
SUBNET MASK [255.255.0.0] :
2. Set up network environment for MG-COT Card SP mode (SP-3875 6MG COT PROG-A Ver.3.0.0.0 or
later)
This command is used to setup the basic data for SP mode. Setting display differs whether DHCP server
and DNS server is used or not. Assign the required network data following the setting command shown in
dialog form. Be sure to save the entered data at the last of SETUP command.
The designated operating status cannot refer when SP-3875 6MG COT PROG-A Ver.3.0.0.0 or later.
Note:
When any abnormal data is entered, the dialog asks to enter proper data until three times. In the third time
Note:
you enter abnormal data, the SETUP command quits discarding all the entered data.
When you quit the SETUP command entry halfway through the setting, all the entered data is to be discard-
Note:
ed.
Startup SETUP SIP:
MG-COT >
MG-COT > setup sp
--- input :1
--- input :2
--- input :3
--- input :4
--- input :5
VOL.2-576
MG-COT Card [SCA-6COTA/SCA-6COTC]
Enter "n".
Data items to change are listed.
Enter the item number to be changed.
IP address is entered.
Subnet mask is entered.
Enter "b" to change the Subnet mask set-
ting.
Returns to Subnet mask setting line.
Enter "SETUP SP" following the prompt.