NEC Univerge sv8500 Manual page 1216

In SET command, some of the sub commands can be specified with hexadecimal numbers (called Set Value), which deter-
mine a group of the detailed values. It is also possible to omit its parameters; the interactive guidance will help you speci-
fying its detailed values. The following shows this patterns:
When the parameters are specified:
MG -PRI> SET TCS_E1_1 9080
set value is 0x9080
setting complete.
In order to make a setup reflect, re-starting is required
after saving a configuration file by SAVE command.
When the parameters are Not specified:
MG -PRI> SET TCS_E1_1
Dch Control
Dch Mode
Dch Signal Logic
Dch-1 Drop/Insert
Dch-2 Drop/Insert
Drop/Insert Mode
Data Transfer Speed ( 0-2:0 ): 0
Drop/Insert Time Slot ( 1-31:16 ): 16
Dch Signaling Set (0/1:0):0
set value is 0x9080
setting complete.
In order to make a setup reflect, re-starting is required
after saving a configuration file by SAVE command.
13.4.2 How to Read Maintenance Command in This Section
The commands in this section are explained with defined characters. These characters' meanings are in the fol-
lowing:
CHARACTERS
P1, P2, P3
( 0/1:1 ): 1
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:1 ): 1
( 0/1:0 ): 0
( 0/1:0 ): 0
Δ
[ ]
Set Value
Blank
Parameters
Parameter Option (indicates Not essential)
VOL.2-963
MG-PRI/PRA
MEANING