NEC Univerge sv8500 Manual page 429

14. Setting the communication speed for LAN interface:
MC(SIP)> SET
SPEED (AUTO/100M/10M)[AUTO]:
DUPLEX (FULL/HALF)[HALF]: FULL
Ethernet Speed setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
DUPLEX setting is not shown when Auto Negotiation (AUTO) is selected in the Speed setting.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
15. Setting IP Address and Net Mask of 8LC Card:
MC(SIP)> SET IPADDRESS P1 P2
IP Address setting succeeded.
The designated IP address cannot be applied when the DHCP is set to Enabled. Assign the DHCP setting
Note:
to Disable before executing this IP address setting.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
16. Setting Internal Music-on-Hold type:
MC(SIP)> SET MUSICTYPE P1
Music on Hold Type setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
INTERFACE
100M
Select the communication speed
AUTO=Auto Negotiation (default)
100M=100 Mbps fixed mode
10M=10 Mbps fixed mode
Select the Duplex mode
FULL=Full Duplex mode
HALF=Half Duplex mode
Result is shown.
P1: Enter the IP Address
(e.g. IP address: 150.10.1.101
P2: Enter the Subnet Mask
(e.g. Subnet mask: 255.255.255.0)
Result is shown.
P1: Select the Internal Music-on-Hold type [0/1]
0=Minuet (default)
1=For Elise
Result is shown.
VOL.2-176