NEC Univerge sv8500 Manual page 1137

LAN1 of the Telephony Server is used for the communication between SIP server and MG(BRI). So assign
Note 2:
IP address of LAN1 on the Telephony Server here. In the case of Dual Configuration, assign IP address of
LAN1 on Telephony Server#0.
Ethernet Speed set
Assign the LAN interface data.
--- Ethernet Speed set ---
Current LAN Speed: 100MBPS_FD
Change LAN Speed? [Y (change)/N (current)/
Q(quit)]: y
Input new Speed [1 (AUTO)/2 (100M)/3(10M)]: 1
DUPLEX setting is not displayed when Auto negotiation is selected.
Note:
Assign the proper speed adjusting the network devices (router, HUB) on the destination.
Note:
Signaling Port Number set
Assign the port number of PHI signaling [PHI = internal controlling function in SIP server (i.e. SP-PHI)].
--- Signaling Port Number set ---
Current Signaling Port Number: 64000
Change Signaling Port Number? [Y (change)/N (cur-
rent)/Q(quit)]: y
Input new Signaling Port Number (1024-65535):
65000
Specify the same port number assigned on SIP server.
Note:
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Select the transmission speed of LAN interface.
1: Auto negotiation (default)
2: 100 Mbps fixed mode
3: 10 Mbps fixed mode
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Enter the port number of PHI signaling.
Port number: 1024~65535
(default = 64000)
VOL.2-884
MG(BRI) [SCA-2BRIA/MG-2BRIA]