NEC Univerge sv8500 Manual page 1205

Hide thumbs Also See for Univerge sv8500:

Table of Contents

The following describe the procedures for the Telephony Server by using PCPro. This describes parameters re-

quired only for the MG-PRI/PRA setting. For more information, refer to the Command Manual.

Specify System Data

Open ASYD command and specify the following:

INDEX186 Bit6 = 1 (indicates ISDN)

INDEX187=00 (Fixed)

INDEX474 Bit 0

INDEX474 Bit 4

To set OG Guard timer to 512 ms, 18 (H) will be specified. (default value: 256ms)

Enable Internal PHI-PRI by ASYDL

Open ASYDL command and enable the Internal PHI-PRI.

SYS1 INDEX 880 Bit1 = 1 (Internal PHI-PRI is available.)

Specify Location ID data of Internal PHE. Select "Network Address" radio button in ALOCL com-

Open ALOCL command and assign ToS for the Internal PHI-PRI.

Internal PHI-PRI module needs to be initialized by ADPM command after changing Location ID data.

MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask

Bit=32 is automatically set when Network Address=0.0.0.0.

Assign the Location ID in the range of 0-4095, associated with the Network Address. When

Network Address=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).

LOC-ID=0 is predetermined to the Location ID of the Telephony Server.

Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.

IP PRECEDENCE/DIFFSERV:

Through Put:

Reliability:

Telephony Server Settings via PCPro

3=MTC (Miscellaneous Timer Counter)

6=TC (Timer Class 01: 64ms period)

Enter the Network Address. For the Telephony Server, assign "0.0.0.0."

Specify the precedence in the range of 0-7 (low-high).

Place a checkmark to set Low Delay to ON.

Place a checkmark to set High Throughput to ON.

Place a checkmark to set High Reliability to ON.

Place a checkmark to set Cost Precedence to ON.

Specify the DiffServ Code Point in the range of 0-63.

Show Quick Links

Table of Contents