NEC Univerge sv8500 Manual page 1147

About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
15. SET SMOOTH_PAD
Assign the Smooth PAD
MG-BRI>set smooth_pad
Input Smooth PAD(0/1/2/3/4/5=OFF/+2dBm/-5dBm/-2dBm/0dBm/-4dBm): 1
Default configuration is '1',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
16. SET VALUE
Assign the VALUE
• When assigning whether to use MG Based Call Retention or not.
MG-BRI>set VALUE CONFIG CALL_HOLD P1
Configuration data was changed into 'P1'.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
By setting "ENABLE" by this command, if a network failure occurred between Telephony Server and MG
Note 1:
(BRI), the call will be retained. However, re-registration to the Telephony Server will not be executed.
"CONFIG CALL_HOLD" must be entered in upper case letters.
Note 2:
Other than "ENABLE" or "DISABLE" must not be entered for "P1".
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
VOL.2-894
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Specify the mode
0: DSP Smooth PAD is not used
1: +2 dBm (default)
2: -5 dBm
3: -2 dBm
4: 0 dBm
5: -4 dBm
,
Note 1 Note 2
P1: ENABLE / DISABLE
ENABLE=CALL_HOLD is valid
DISABLE=CALL_HOLD is
invalid (default)