NEC Univerge sv8500 Manual page 1183

REBOOT
This command is used to reboot the MG(BRI).
[Normal occasion]
MG-BRI(SIP)> REBOOT
Do you need reboot? [Y/N]: Y
[When configuration data is changed]
MG-BRI(SIP)> REBOOT
Do you need reboot? [Y/N]: Y
Configuration data was changed.
** Don't power off in progress**
y: Save and Reboot
n: Reboot without saving
c: Cancel
[Y/N/C]: Y
Configuration data has been saved!!
The screen returns to the prompt of the configuration command [MG-BRI(SIP)>] if any error occurs after
Note:
selecting "Y".
EXIT
This command is used to exit the configuration command.
[Normal occasion]
MG-BRI(SIP)> EXIT
Finished!
->
[When configuration data is changed]
MG-BRI(SIP)> EXIT
Enter "Y" to execute the command.
Enter "Y" to execute the command.
Enter "Y" to save and execute rebooting.
VOL.2-930
MG(BRI) [SCA-2BRIA/MG-2BRIA]