NEC Univerge sv8500 Manual page 1175

23. SET WARNING_TONE_CONTROL
Assign whether to use warning tone when LAN failure or not.
MG-BRI(SIP> SET WARNING_TONE_CONTROL
Warning Tone Control setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
P1
VOL.2-922
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: Setting of Mode (Default: 3)
0: Do
not send warning tone
1: Send warning tone to IP network side.
2: Send warning tone to ISDN side.
3: Send warning tone to IP network and
ISDN.
The result is shown.