NEC Univerge sv8500 Manual page 1253

Δ
23. SHOW VERSION P1
This command is used to display information about hardware and software.
MG-PRI > SHOW VERSION NC
MG Maintenance command Version 1.00
2001.07.01
NC Version information
Hardware : PZ-CC150 XXXX
Boot program : SP-3664
Firmware : SP-3667
24. SHOW Δ VLAN Δ [P1]
This command is used to display the VLAN.
COMMAND 1
MG-PRI > SHOW VLAN
DEVICE ID COS IPADDRESS
VLAN1 1 0 10.123.123.123
COMMAND 2
MG-PRI > SHOW VLAN 1
DEVICE ID COS IPADDRESS
VLAN1 1 0 10.123.123.123
25. SHOW Δ WARNING_TONE
MG-PRI > SHOW WARNING_TONE
Waning Tone Control of IP Network is 3(IP&ISDN
side).
P1- Specify the version to be displayed.
XXXX
The current setting is displayed.
XXXX
SUBNETMASK
255.255.255.0
SUBNETMASK
255.255.255.0
VOL.2-1000
NC: Network Control
TC: Trunk Control
VC0: Voice Compression 0
VC1: Voice Compression 1
P1- Specify VLAN ID.
If omitted, all the VLAN are displayed.
The current setting is displayed.
-When specifying VLAN ID, COMMAND1 is dis-
played.
-When omitting VLAN ID, COMMAND2 is dis-
played.
The current setting of WANING TONE
is displayed.
MG-PRI/PRA