NEC Univerge sv8500 Manual page 1110

<Help>
What to enter next can be confirmed by entering ["?"] after the command. For example, to confirm what to enter
after the "SET" command will be ["SET (Command Name)" + "?"]. To confirm the parameter after the Sub-
command, it will be ["SET (Command Name)" + "OWN_IPADDRESS (Sub-command Name) + "?"]. Help
screen of "SET" command is shown below as an example.
MG-BRI>SET?
INTERFACE
DHCP_SV
DNS_SV
DNS_IPADDRESS
SIPSV_IPADDRESS
OWN_IPADDRESS
DEFAULT_GATEWAY
SIGNALING_QOS
SIGNALING_PORT_NO
VLAN
LAN_ERROR_CHECK
FAX_DETECTION_TIME
SMOOTH_PAD
HC_RCV_TIMER
WARNING_TONE_CONTROL
ONE_TIME_PASS
Setting Ethernet Speed (Def. AUTO)
Setting DHCP interface (Def. DISABLE)
Setting DNS Interface (Def. DISABLE)
Setting DNS IP Address (Def. 0.0.0.0)
Setting SIP Server IP Address & Port Number & Host Name
(Def. 0.0.0.0/5060/blank)
Setting IP Address & Subnetmask & Host Name
(Def. 0.0.0.0/0.0.0.0/blank)
Setting Default Gateway IP Address (Def. 0.0.0.0)
Setting Signaling QOS (Def.IP Precedence[0xC0])
Setting Signaling Port Number (Def. 64000)
Setting VLAN Information (Def. Not use VLAN)
Setting LAN Error Check Timer (Def. 1000ms)
Setting FAX Enable Timer (Def. 1)
Setting Smooth PAD mode (Def. 1)
Setting Health-Check Receive Timer Timeout (Def. 150s)
Setting Warning Tone Control of IP Network (Def. 3)
Setting One Time Password (Def. blank)
VOL.2-857
MG(BRI) [SCA-2BRIA/MG-2BRIA]