NEC Univerge sv8500 Manual page 1209

Specify CIC Information
STEP 10
Open ACIC1 command and specify the accommodated location of Virtual Control Channel on Point Code.
as follows:
NDM command (ACIC1N) cannot be used here.
Note:
PC: Enter the Point Code specified by ADPC
CSCG: Enter the CSC group specified by ACSC
Specify the trunk data for Dch referring to STEP 7.
STEP 11
Open ATRK command and specify trunk data on Virtual Speech Channel.
Specify Trunk Make-Busy
STEP 12
Open MBTK command to cancel Make Busy of Virtual Speech Channel.
RT: Specify the Route Number
TK: Specify the Trunk Number
MB=0 (Indicates Make-Busy is cancelled.)
Specify MG-PRI/PRA related information
STEP 13
Open AMGIL command and register information regarding to MG-PRI/PRA as follows:
MG-ID: Specify the MAC Address (6 bytes)
KIND: Specify an ISDN Trunk (PRI 1.5M / 2M)
LINE=0 (fixed)
CH=0 (fixed)
LENS: Specify a Basic Accommodated Location (top of HW)
Retry: Specify a Retry Number of demanding request for MG-PRI/PRA connection
Service Type: Specify QoS settings of Signaling (indicating ToS when Internal PHI-PRI connects to MG-
PRI/PRA)
Specify MG-PRI/PRA Voice Control Data
STEP 14
Open AMGVL command and register the voice control data when connecting to MG-PRI/PRA. If the set-
tings are not specified with this command, the values will be set to "G711" and "40ms" automatically.
A RT (MG Storing): Physical route number of Virtual Speech Channel (connected point)
TYPE: Select one of the followings:
Route Specified
Location ID Specified
B RT (MG Storing)
Displayed when TYPE=Route Specified is selected.
Specify the Physical Route Number (MG)
VOL.2-956
MG-PRI/PRA