NEC Univerge sv8500 Manual page 1155

EXIT Command
This command is used to exit the configuration command of MG(BRI).
Save the latest configuration using SAVE command and then exit. Confirmation message appears when the
configuration has not been saved.
MG-BRI>exit
Configuration data was changed.
** Don't power off in progress **
y:Save and Exit
n:Exit without saving
c:Cancel
[y/n/c]:y
Configuration data has been saved.
finished!
Key entry will be denied when executing "EXIT" command following the OS prompt (
Note:
press Ctrl key and C key simultaneously to display OS prompt again.
Enter "Y" to execute this command.
VOL.2-902
MG(BRI) [SCA-2BRIA/MG-2BRIA]
−> ). In this case,