NEC Univerge sv8500 Manual page 1117

12.4.6 Standard Mode
Data setting in this section is an example. Assign the data adjusting your network configuration.
Note:
DHCP Interface set
Assign whether to use DHCP server.
--- DHCP Interface set ---
Current DHCP Interface: Disable
Change DHCP Interface? [Y(change)/N(current)/Q(quit)]:y
Input new DHCP Interface [E(enable)/D(disable)]: e
DNS Interface set
Assign whether to use DNS server.
--- DNS Interface set ---
Current DNS Interface: Disable
Change DNS Interface? [Y(change)/N(current)/Q(quit)]:y
Input new DNS Interface [E(enable)/D(disable)]: e
<Standard mode for w/ DHCP server and w/ DNS server configuration>
Ethernet Speed set
Assign the LAN interface data.
--- Ethernet Speed set ---
Current LAN Speed: 100MBPS_FD
Change LAN Speed? [Y (change)/N (current)/
Q(quit)]: y
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Specify whether to use DHCP server
E: DHCP server is used
D: DHCP server is not used (default)
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Specify whether to use DNS server
E: DNS server is used
D: DNS server is not used (default)
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
VOL.2-864
MG(BRI) [SCA-2BRIA/MG-2BRIA]