NEC Univerge sv8500 Manual page 1161

Setting Ethernet Speed
--- Ethernet Speed set ---
Current LAN Speed: AUTO
Change LAN Speed? [Y(change)/N(current)/
Q(quit)]: Y
Input new Speed [1(AUTO)/2(100M)/3(10M)]: 2
Input new DUPLEX [F(full)/H(half)]: F
Setting Signaling Port Number
--- Signaling Port Number set ---
Current Signaling Port Number: 5060
Change Signaling Port Number? [Y(change)/
N(current)/Q(quit)]: Y
Input new Signaling Port Number (1024-65535):
5060
Specify the same port number assigned on SIP server.
Note:
The current setting is displayed.
Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Select the communication speed of LAN interface
1=Auto negotiation (default)
2=100Mbps fixed mode
3=10Mbps fixed mode
Select the Duplex mode of LAN interface Note 1
F=Full duplex mode
H=Half duplex mode
When the communication speed of
Note 1:
LAN interface is "1 (Auto negotia-
tion)", this setting is not required.
The current setting is displayed.
Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Enter the port number of PHI signaling.
Port number: 1024-65535
(default = 5060)
VOL.2-908
MG(BRI) [SCA-2BRIA/MG-2BRIA]