NEC Univerge sv8500 Manual page 1164

A maximum one of VLAN can be registered.
Note:
When using VLAN, assign "0.0.0.0" for IP address of actual LAN by using "SET OWN_IPADDRESS"
Note:
command.
If "0" is assigned for VLAN ID, VLAN will be disabled.
Note:
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
Note:
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
Save the assigned configuration data at the last of SETUP SP command to complete net-
work setting.
**Don't power off in progress**
Do you save the configuration data? (Y/N):Y
Configuration data has been saved.
Re-starting is required for making a setup
reflect!!
SP mode setting succeeded.
If abnormal data is entered four times continuously, the setup will be quit without saving all the assigned
Note:
configuration data.
If the setup is quit on the way, all of the assigned configuration data will not be saved.
Note:
Asked whether to save the assigned data.
Y=Save
N=Not save
Result is displayed.
VOL.2-911
MG(BRI) [SCA-2BRIA/MG-2BRIA]