NEC Univerge sv8500 Manual page 1103

- Data: 8 bits
- Parity: None
- Stop Bit: 1
- Flow Control: None
Standard Mode
Display changes as follows when Standard mode is selected on the main menu. Standard mode displays
necessary commands in order. Assign the basic network data in dialog format.
<Dialogue Format Command Entry (example)>
--- DNS IP Address set ---
Current DNS IP Address: 0.0.0.0
Change DNS Interface? [Y(change)/N(current)/Q(quit)]: y
Input new DNS IP Address: 10.41.1.150
When any abnormal data is input, the dialog ask to enter proper data until three times. In the fourth time
-
Note:
you enter abnormal data, the command quits the Standard mode discarding the input data.
When all the necessary data is assigned properly, the assigned data is listed before exiting the Standard
-
mode. (The same list of SHOW CONFIG command in Custom mode.) Input "Y" and press Enter key
when asked to save the data. Standard mode ends and back to the main menu of configuration command.
- When you quit the command entry halfway through the Standard mode, all the input data is to be dis-
carded.
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode and back to main
menu
Input "Y" and press Enter key to change the cur-
rent data. Input "N" to skip this command and
go on to the next command.
This line is displayed to assign the data only
when "Y" is selected in the former step.
Input the IP address of DNS server (e.g.
10.41.1.150), and press Enter key.
VOL.2-850
MG(BRI) [SCA-2BRIA/MG-2BRIA]