NEC Univerge sv8500 Manual page 1113

<Maintenance Command List>
SETUP
Sub-command
1 SP
SET: Command to assign the configuration data
Sub-command
1 CALL_HOLD
2 DEFAULT_GATEWAY
3 DHCP_SV
4 DNS_IPADDRSS
5 DNS_SV
6 DTMF_IN
7 FAX_DETECTION_TIME
8 HC_RCV_TIMER
9 INTERFACE
10 LAN_ERROR_CHECK
11 ONE_TIME_PASS
12 OWN_IPADDRESS
13 RTP_START_PORT_NO
14 RTP_STOP_DETECT
15 SIGNALING_PORT_NO
16 SIGNALING_QOS
17 SIP_MADDR
18 SIP_RPORT
19 SIPSV_IPADDRESS
20 SMOOTH_PAD
21 SUBSCRIBE_RETRY
SETUP COMMAND
Assign whether to use MG Based Call Retention or not.
Assign the IP address of Default Gateway.
Assign whether to use DHCP Server or not.
Assign the IP Address of DNS server.
Assign whether to use DNS server or not.
Assign whether Inband DTMF is used or not.
Assign the effective switching timer for FAX
Assign the Time-out value for Telephony Server health check wait-
ing process.
Assign the speed and activation mode of Ether controller.
Assign the interval to detect LAN cable fall-off
Assign the one time password to be used for the first registration af-
ter connected to network.
Assignment of IP Address, Subnet Mask, and Host Name of
MG(BRI) itself.
Specify the first port number to be used for RTP.
Specify a time-out value for MG Based Call Retention.
Assign the port number to be used for PHI signaling.
Assign the ToS value added to signaling (SIP server signaling) ses-
sion.
Select the mode to use the maddr parameter in Via header of SIP
message or not.
Select the mode to use the rport parameter in Via header of SIP mes-
sage or not.
Assign the IP address, port number, and host name of SIP server.
Assign the Smooth PAD
Select the regeneration mode for SIP SUBSCRIBE session.
VOL.2-860
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Function
Function