NEC Univerge sv8500 Manual page 1171

Meaning of ToS field for IP Precedence type is as follows.
Note:
Prec.
• When P1 = Diffserv is specified:
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:D
DSCP(0-63:48):48
Meaning of ToS field for Diffserv type is as follows
Note:
DSCP
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
17. SET SIP_MADDR
Select the mode to use the maddr parameter in Via header of SIP message or not.
MG-BRI(SIP)> SET SIP_MADDR
SIP maddr setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
The maddr parameter indicates that it is the destination IP address of SIP response in Via header of SIP
Note:
message. MG-BRI will operate as follows depending on the setting.
- 0: Not to be used.
Even if maddr parameter is in Via header of SIP request received by MG-BRI, SIP response will be trans-
ferred to the originating IP address without using the maddr parameter. The maddr parameter will not be
added to Via header of SIP request to be transferred from MG-BRI.
- 1: To be used for reception.
If maddr parameter is in Via header of SIP request received by MG-BRI, SIP response will be transferred
D T R C
P1
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
.
DSCP = Differentiated Service Code Point (6 bits)
VOL.2-918
MG(BRI) [SCA-2BRIA/MG-2BRIA]
D: When (Diffserv) is selected.
Enter DSCP value (0-63)
(Default: 48)
P1: Select the mode
Effective range: 0-3 (Default: 1)
0: Not to be use.
1: To be used for reception.
2: To be used for transmission.
3: To be used for reception and transmission.
The result is shown.