NEC Univerge sv8500 Manual page 1220

Δ Δ Δ
2. SET COS P1 P2
This command is used to modify Class of Service (COS). Using this command is available while VLAN is
working. To make this assignment effective, it is required to execute the "SAVE" command and to restart
before exiting the maintenance command.
MG-PRI> SET COS 1 7
COS setup complete.
In order to make a setup reflect, re-starting is
required after saving a configuration file by SAVE
command.
Δ
3. SET DEFAULTROUTE
This command is used to specify IP address for Default Gateway. To make this assignment effective, it is
required to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI> SET DEFAULTROUTE 150.12.0.254
Default gateway address set complete.
In order to make a setup reflect, re-starting is
required after saving a configuration file by SAVE
command.
Δ
P1
VOL.2-967
MG-PRI/PRA
P1-VLAN ID
1-4094=VLAN_ID
P2-COS value
0-7=COS
A command is executed, and the re-
sult is displayed.
P1-Specify Default Gateway ad-
dress
A command is executed, and the re-
sult is displayed.